Earth's Plate Tectonics Fired Up Hundreds of Millions of Years Earlier Than Thought - 17 July, 2024 07:30 AM
Africa Emerges as Focal Point in Global Oil and Gas Exploration - 17 July, 2024 07:30 AM
Oil and Gas Development in Permian Basin a Likely Source of Ozone Pollution in Carlsbad Caverns National Park - 17 July, 2024 07:30 AM
Bolivia Discovers Huge Natural Gas Field - 17 July, 2024 07:30 AM
Kenyan Government Rejects Tullow Oil’s Field Plan - 17 July, 2024 07:30 AM
The influence of moisture, temperature, coal rank, and differential enthalpy on the methane (CH4) and carbon dioxide (CO2) sorption capacity of coals of different rank has been investigated by using high-pressure sorption isotherms at 303, 318, and 333 K (CH4) and 318, 333, and 348 K (CO2), respectively. The variation of sorption capacity was studied as a function of burial depth of coal seams using the corresponding Langmuir parameters in combination with a geothermal gradient of 0.03 K/m and a normal hydrostatic pressure gradient. Taking the gas content corresponding to 100% gas saturation at maximum burial depth as a reference value, the theoretical CH4 saturation after the uplift of the coal seam was computed as a function of depth. According to these calculations, the change in sorption capacity caused by changing pressure, temperature conditions during uplift will lead consistently to high saturation values. Therefore, the commonly observed undersaturation of coal seams is most likely related to dismigration (losses into adjacent formations and atmosphere). Finally, we attempt to identify sweet spots for CO2-enhanced coalbed methane (CO2-ECBM) production. The CO2-ECBM is expected to become less effective with increasing depth because the CO2-to-CH4 sorption capacity ratio decreases with increasing temperature and pressure. Furthermore, CO2-ECBM efficiency will decrease with increasing maturity because of the highest sorption capacity ratio and affinity difference between CO2 and CH4 for low mature coals.
Using diverse geologic and geophysical data from recent exploration and development, and experimental results of analysis of gas content, gas capacity, and gas composition, this article discusses how geologic, structural, and hydrological factors determine the heterogeneous distribution of gas in the Weibei coalbed methane (CBM) field. The coal rank of the Pennsylvanian no. 5 coal seam is mainly low-volatile bituminous and semianthracite. The total gas content is 2.69 to 16.15 m3/t (95.00–570.33 scf/t), and gas saturation is 26.0% to 93.2%. Burial coalification followed by tectonically driven hydrothermal activity controls not only thermal maturity, but also the quality and quantity of thermogenic gas generated from the coal. Gas composition indicates that the CBM is dry and of dominantly thermogenic origin. The thermogenic gases have been altered by fractionation that may be related to subsurface water movement in the southern part of the study area. Three gas accumulation models are identified: (1) gas diffusion and long-distance migration of thermogenic gases to no-flow boundaries for sorption and minor conventional trapping, (2) hydrodynamic trapping of gas in structural lows, and (3) gas loss by hydrodynamic flushing. The first two models are applicable for the formation of two CBM enrichment areas in blocks B3 and B4, whereas the last model explains extremely low gas content and gas saturation in block B5. The variable gas content, saturation, and accumulation characteristics are mainly controlled by these gas accumulation models.
Sequence stratigraphy and coal cycles based on accommodation trends were investigated in the coal-bearing Lower Cretaceous Mannville Group in the Lloydminster heavy oil field, eastern Alberta. The study area is in a low accommodation setting on the cratonic margin of the Western Canada sedimentary basin. Geophysical log correlation of coal seams, shoreface facies, and the identification of incised valleys has produced a sequence-stratigraphic framework for petrographic data from 3 cored and 115 geophysical-logged wells. Maceral analysis, telovitrinite reflectance, and fluorescence measurements were taken from a total of 206 samples. Three terrestrial depositional environments were interpreted from the petrographic data: ombrotrophic mire coal, limnotelmatic mire coal, and carbonaceous shale horizons. Accommodation-based coal (wetting- and drying-upward) cycles represent trends in depositional environment shifts, and these cycles were used to investigate the development and preservation of the coal seams across the study area. The low-accommodation strata are characterized by a high-frequency occurrence of significant surfaces, coal seam splitting, paleosol, and incised-valley development. Three sequence boundary unconformities are identified in only 20 m (66 ft) of strata. Coal cycle correlations illustrate that each coal seam in this study area was not produced by a single peat-accumulation episode but as an amalgamation of a series of depositional events. Complex relations between the Cummings and Lloydminster coal seams are caused by the lateral fragmentation of strata resulting from the removal of sediment by subaerial erosion or periods of nondeposition. Syndepositional faulting of the underlying basement rock changed local accommodation space and increased the complexity of the coal cycle development. This study represents a low-accommodation example from a spectrum of stratigraphic studies that have been used to establish a terrestrial sequence-stratigraphic model. The frequency of changes in coal seam quality is an important control on methane distribution within coalbed methane reservoirs and resource calculations in coal mining. A depositional model based on the coal cycle correlations, as shown by this study, can provide coal quality prediction for coalbed methane exploration, reservoir completions, and coal mining.
Regional variations in thickness and facies of clastic sediments are controlled by geographic location within a foreland basin. Preservation of facies is dependent on the original accommodation space available during deposition and ultimately by tectonic modification of the foreland in its postthrusting stages. The preservation of facies within the foreland basin and during the modification stage affects the kinds of hydrocarbon reservoirs that are present. This is the case for the Cretaceous Mowry Shale and Frontier Formation and equivalent strata in the Rocky Mountain region of Colorado, Utah, and Wyoming. Biostratigraphically constrained isopach maps of three intervals within these formations provide a control on eustatic variations in sea level, which allow depositional patterns across dip and along strike to be interpreted in terms of relationship to thrust progression and depositional topography. The most highly subsiding parts of the Rocky Mountain foreland basin, near the fold and thrust belt to the west, typically contain a low number of coarse-grained sandstone channels but limited sandstone reservoirs. However, where subsidence is greater than sediment supply, the foredeep contains stacked deltaic sandstones, coal, and preserved transgressive marine shales in mainly conformable successions. The main exploration play in this area is currently coalbed gas, but the enhanced coal thickness combined with a Mowry marine shale source rock indicates that a low-permeability, basin-centered play may exist somewhere along strike in a deep part of the basin. In the slower subsiding parts of the foreland basin, marginal marine and fluvial sandstones are amalgamated and compartmentalized by unconformities, providing conditions for the development of stratigraphic and combination traps, especially in areas of repeated reactivation. Areas of medium accommodation in the most distal parts of the foreland contain isolated marginal marine shoreface and deltaic sandstones that were deposited at or near sea level lowstand and were reworked landward by ravinement and longshore currents by storms creating stratigraphic or combination traps enclosed with marine shale seals. Paleogeographic reconstructions are used to show exploration fairways of the different play types present in the Laramide-modified, Cretaceous foreland basin. Existing oil and gas fields from these plays show a relatively consistent volume of hydrocarbons, which results from the partitioning of facies within the different parts of the foreland basin.
It’s all about staying on target: Technological advances are helping to make geosteering an increasingly valuable tool for geologists involved in horizontal wells.
Added to the 'first-time-ever” list was the announcing of paper and poster awards at the end of the event.
Recount: The U.S. Geological Survey offers a new estimate of the world’s undiscovered conventional oil and gas resources.
A world-class technical program is in place for the AAPG International Conference and Exhibition in Singapore.
My co-author for this month’s column is Jim McGhay, AAPG Treasurer. Later this month, you will receive your dues statement, where there are two items that might attract your attention. We address them here.
If you have a pulse and have been to an AAPG Annual Convention and Exhibition (ACE) over the past couple of years or so, or a recent AAPG International Convention and Exhibition (ICE) such as those held in Calgary or Milan, you would have noticed.
This presentation will look at well placement vertically in the pay, well azimuth and well trajectory with explanations of how geology and post-depositional effects can make the difference between a successful well and a failure.
This e-symposium will focus on how surface geochemical surveys and Downhole Geochemical Imaging technologies can be utilized jointly to directly characterize the composition of hydrocarbons vertically through the prospect section.
Visiting Geoscientist Mauricio Guizada provides an overview of general structural geology of the Andes, with a focus on the Central Andes. His talk covers topics related to onshore exploration, G&G methods in exploration and risk analysis. Join Mauricio Guizada via Zoom on June 23 at 4pm CDT.
This e-symposium will be introducing signal processing techniques as a means to maximize extracting geomechanical data from petrophysical logs.
Visiting Geoscientist Susan Morrice shares her personal experience and insight in this talk about opportunities for geoscientists. “Geoscientists have advantages ... They are Time Travellers and have open minds. Bringing this creativity and innovation to your company or starting your own! Challenging times bring silver linings!”
As commodity prices have dropped, many shale plays have become uneconomical as statistical plays and have increasingly become recognized as geological plays demanding new insights from data.
Projects in several shales will be discussed, including Marcellus, Eagle Ford, Haynesville, Fayetteville, Montney, and Barnett, as will several seismically-detectable drivers for success including lithofacies, stress, pre-existing fractures, and pore pressure.
This study will focus in the combination of λρ – μρ inversion with clustering analysis techniques in order to discriminate brittle zones in the Barnett Shale.
Expanded package for CEU credit is $100 for AAPG members, and $145 for non-members. Special Student Pricing: $25 for Webinar only; $35 for Expanded package.
Recent interest in unconventional gas resources has attracted several oil and gas explorers to sedimentary basins in Southern Quebec.
Production from unconventional petroleum reservoirs includes petroleum from shale, coal, tight-sand and oil-sand. These reservoirs contain enormous quantities of oil and natural gas but pose a technology challenge to both geoscientists and engineers to produce economically on a commercial scale. These reservoirs store large volumes and are widely distributed at different stratigraphic levels and basin types, offering long-term potential for energy supply. Most of these reservoirs are low permeability and porosity that need enhancement with hydraulic fracture stimulation to maximize fluid drainage. Production from these reservoirs is increasing with continued advancement in geological characterization techniques and technology for well drilling, logging, and completion with drainage enhancement. Currently, Australia, Argentina, Canada, Egypt, USA, and Venezuela are producing natural gas from low permeability reservoirs: tight-sand, shale, and coal (CBM). Canada, Russia, USA, and Venezuela are producing heavy oil from oilsand. USA is leading the development of techniques for exploring, and technology for exploiting unconventional gas resources, which can help to develop potential gas-bearing shales of Thailand. The main focus is on source-reservoir-seal shale petroleum plays. In these tight rocks petroleum resides in the micro-pores as well as adsorbed on and in the organics. Shale has very low matrix permeability (nano-darcies) and has highly layered formations with differences in vertical and horizontal properties, vertically non-homogeneous and horizontally anisotropic with complicate natural fractures. Understanding the rocks is critical in selecting fluid drainage enhancement mechanisms; rock properties such as where shale is clay or silica rich, clay types and maturation , kerogen type and maturation, permeability, porosity, and saturation. Most of these plays require horizontal development with large numbers of wells that require an understanding of formation structure, setting and reservoir character and its lateral extension. The quality of shale-gas resources depend on thickness of net pay (>100 m), adequate porosity (>2%), high reservoir pressure (ideally overpressure), high thermal maturity (>1.5% Ro), high organic richness (>2% TOC), low in clay (<50%), high in brittle minerals (quartz, carbonates, feldspars), and favourable in-situ stress. During the past decade, unconventional shale and tight-sand gas plays have become an important supply of natural gas in the US, and now in shale oil as well. As a consequence, interest to assess and explore these plays is rapidly spreading worldwide. The high production potential of shale petroleum resources has contributed to a comparably favourable outlook for increased future petroleum supplies globally. Application of 2D and 3D seismic for defining reservoirs and micro seismic for monitoring fracturing, measuring rock properties downhole (borehole imaging) and in laboratory (mineralogy, porosity, permeability), horizontal drilling (downhole GPS), and hydraulic fracture stimulation (cross-linked gel, slick-water, nitrogen or nitrogen foam) is key in improving production from these huge resources with low productivity factors.
Request a visit from Ameed Ghori!