Shale may be the reservoir du jour, but a wide range of conventional reservoirs still hold promise in diverse regions throughout the world.
In reservoir engineering, hydrodynamic properties can be estimated from downhole electrical data using heuristic models (e.g., Archie and Kozeny-Carman's equations) relating electrical conductivity to porosity and permeability. Although proven to be predictive for many sandstone reservoirs, the models mostly fail when applied to carbonate reservoirs that generally display extremely complex pore network structures. In this article, we investigate the control of the three-dimensional (3-D) geometry and morphology of the pore network on the electrical and flow properties, comparing core-scale laboratory measurements and 3-D x-ray microtomography image analysis of samples from a Miocene reefal carbonate platform located in Mallorca (Spain). The results show that micrometer- to centimeter-scale heterogeneities strongly influence the measured macroscopic physical parameters that are then used to evaluate the hydrodynamic properties of the rock, and therefore, existing models might not provide accurate descriptions because these heterogeneities occur at scales smaller than those of the integration volume of the borehole geophysical methods. However, associated with specific data processing, 3-D imagery techniques are a useful and probably unique mean to characterize the rock heterogeneity and, thus, the properties variability.
The Tarim Basin is one of the most important hydrocabon-bearing evaporite basins in China. Four salt-bearing sequences, the Middle and Lower Cambrian, the Mississippian, the Paleogene, and the Neogene, have various thickness and areal distribution. They are important detachment layers and intensely affect the structural deformation in the basin. The Kuqa depression is a subordinate structural unit with abundant salt structures in the Tarim Basin. Salt overthrusts, salt pillows, salt anticlines, salt diapirs, and salt-withdrawal basins are predominant in the depression. Contraction that resulted from orogeny played a key function on the formation of salt structures. Growth strata reveal that intense salt structural deformation in the Kuqa depression occurred during the Himalayan movement from Oligocene to Holocene, with early structural deformation in the north and late deformation in the south. Growth sequences also record at least two phases of salt tectonism. In the Yingmaili, Tahe, and Tazhong areas, low-amplitude salt pillows are the most common salt structures, and these structures are commonly accompanied by thrust faults. The faulting and uplifting of basement blocks controlled the location of salt structures. The differences in the geometries of salt structures in different regions show that the thickness of the salt sequences has an important influence on the development of salt-cored detachment folds and related thrust faults in the Tarim Basin. Salt sequences and salt structures in the Tarim Basin are closely linked to hydrocarbon accumulations. Oil and gas fields have been discovered in the subsalt, intrasalt, and suprasalt strata. Salt deformation has created numerous potential traps, and salt sequences have provided a good seal for the preservation of hydrocarbon accumulations. Large- and small-scale faults related with salt structures have also given favorable migration pathways for oil and gas. When interpreting seismic profiles, special attention needs to be paid to the clastic and carbonate interbeds within the salt sequences because they may lead to incorrect structural interpretation. In the Tarim Basin, the subsalt anticlinal traps are good targets for hydrocarbon exploration.
Analog outcrops are commonly used to develop predictive reservoir models and provide quantitative parameters that describe the architecture and facies distribution of sedimentary deposits at a subseismic scale, all of which aids exploration and production strategies. The focus of this study is to create a detailed geological model that contains realistic reservoir parameters and to apply nonlinear acoustic full-waveform prestack seismic inversion to this model to investigate whether this information can be recovered and to examine which geological features can be resolved by this process. Outcrop data from the fluviodeltaic sequence of the Book Cliffs (Utah) are used for the geological and petrophysical two-dimensional model. Eight depositional environments are populated with average petrophysical reservoir properties adopted from a North Sea field. These units are termed lithotypes here. Synthetic acoustic prestack seismic data are then generated with the help of an algorithm that includes all internal multiples and transmission effects. A nonlinear acoustic full-waveform inversion is then applied to the synthetic data, and two media parameters, compressibility (inversely related to the square of the compressional wave velocity vP) and bulk density, ρ, are recovered at a resolution higher than the shortest wavelength in the data. This is possible because the inversion exploits the nonlinear nature of the relationship between the recorded data and the medium contrast properties. In conventional linear inversion, these details remain masked by the noise caused by the nonlinear effects in the data. Random noise added to the data is rejected by the nonlinear inversion, contributing to improved spatial resolution. The results show that the eight lithotypes can be successfully recovered at a subseismic scale and with a low degree of processing artifacts. This technique can provide a useful basis for more accurate reservoir modeling and field development planning, allowing targeting of smaller reservoir units such as distributary channels and lower shoreface sands.
In prospective basins affected by exhumation, uncertainty commonly exists regarding the maximum burial depths of source, reservoir, and seal horizons. One such basin is the Otway Basin, an important gas province in southeastern Australia, which has witnessed several exhumation events. Here, we present estimates of net exhumation magnitudes for 110 onshore and offshore petroleum wells based on the sonic transit time analyses of Lower Cretaceous fluvial shales. Our results show significant post-Albian net exhumation in the eastern onshore Otway Basin (1500 m [4920 ft]) and a generally minor net exhumation (200 m [655 ft]) elsewhere in the Otway Basin, consistent with estimates based on thermal history data. The distribution of net exhumation magnitudes in relation to mid-Cretaceous and Neogene compressional structures indicates that exhumation was dominantly controlled by short-wavelength basin inversion driven by plate-boundary forces. Deeper burial coupled with high geothermal gradients in the onshore eastern Otway Basin and along the northern basin margin during the early Cretaceous have rendered Lower Cretaceous source rocks mostly overmature, with any remaining hydrocarbons from the initial charge likely to be trapped in tightly compacted reservoirs and/or secondary (fracture-related) porosity. However, the embrittlement of these reservoirs during their deeper burial may present opportunities for the development of low-permeability plays through hydraulic fracturing where smectite clay minerals are illitized. Source rocks at near-maximum burial at present day are at temperatures suitable for gas generation, with key controls on prospectivity in these areas including the sealing potential of faulted traps and the relationship between charge and trap development.
Criteria for recognizing stratigraphic sequences are well established on continental margins but more challenging to apply in basinal settings. We report an investigation of the Upper Devonian Woodford Shale, Permian Basin, west Texas based on a set of four long cores, identifying sea level cycles and stratigraphic sequences in an organic-rich shale. The Woodford Shale is dominated by organic-rich mudstone, sharply overlain by a bioturbated organic-poor mudstone that is consistent with a second-order eustatic sea level fall. Interbedded with the organic-rich mudstone are carbonate beds, chert beds, and radiolarian laminae, all interpreted as sediment gravity-flow deposits. Bundles of interbedded mudstone and carbonate beds alternate with intervals of organic-rich mudstone and thin radiolaria-rich laminae, defining a 5–10 m (16–33 ft)-thick third-order cyclicity. The former are interpreted to represent highstand systems tracts, whereas the latter are interpreted as representing falling stage, lowstand, and transgressive systems tracts. Carbonate beds predominate in the lower Woodford section, associated with highstand shedding at a second-order scale; chert beds predominate in the upper Woodford section, responding to the second-order lowstand. Additional variability is introduced by geographic position. Wells nearest the western margin of the basin have the greatest concentration of carbonate beds caused by proximity to a carbonate platform. A well near the southern margin has the greatest concentration of chert beds, resulting from shedding of biogenic silica from a southern source. A well in the basin center has little chert and carbonate; here, third-order sea level cycles were primarily reflected in the stratigraphic distribution of radiolarian-rich laminae.
Data derived from core and well-logs are essentially one-dimensional and determining eolian system type and likely dimensions and orientation of architectural elements present in subsurface eolian reservoir successions is typically not possible from direct observation alone. This is problematic because accurate predictions of the three-dimensional distribution of interdune and dune-plinth elements that commonly form relatively low-permeability baffles to flow, of net:gross, and of the likely distribution of elements with common porosity-permeability properties at a variety of scales in eolian reservoirs is crucial for effective reservoir characterization. Direct measurement of a variety of parameters relating to aspects of the architecture of eolian elements preserved as ancient outcropping successions has enabled the establishment of a series of empirical relationships with which to make first-order predictions of a range of architectural parameters from subsurface successions that are not observable directly in core. In many preserved eolian dune successions, the distribution of primary lithofacies types tends to occur in a predictable manner for different types of dune sets, whereby the pattern of distribution of grain-flow, wind-ripple, and grain-fall strata can be related to set architecture, which itself can be related back to original bedform type. Detailed characterization of individual eolian dune sets and relationships between neighboring dune and interdune elements has been undertaken through outcrop studies of the Permian Cedar Mesa Sandstone and the Jurassic Navajo Sandstone in southern Utah. The style of transition between lithofacies types seen vertically in preserved sets, and therefore measurable in analogous core intervals, enables predictions to be made regarding the relationship between preserved set thickness, individual grain-flow thickness, original bedform dimensional properties (e.g., wavelength and height), the likely proportion of the original bedform that is preserved to form a set, the angle of climb of the system, and the likely along-crest variability of facies distributions in sets generated by the migration of sinuous-crested bedforms. A series of graphical models depict common facies arrangements in bedsets for a suite of dune types and these demonstrate inherent facies variability.
Quartet made its debut in the industry this year. The reviews are in and it looks like the value brought to the field is proving it to be innovative and time-saving.
The high-cost of drilling environments has been addressed by a new technology using wireless telemetry to feed real-time data back to the surface. Here's one review.
'The Great American Carbonate Bank' sounds like a great read, doesn't it? Hear what Bill Morgan has to share about this memoir from a great sedimentologist, paleontologist and educator - James Lee Wilson.
As oil and gas exploration and production occur in deeper basins and more complex geologic settings, accurate characterization and modeling of reservoirs to improve estimated ultimate recovery (EUR) prediction, optimize well placement and maximize recovery become paramount. Existing technologies for reservoir characterization and modeling have proven inadequate for delivering detailed 3D predictions of reservoir architecture, connectivity and rock quality at scales that impact subsurface flow patterns and reservoir performance. Because of the gap between the geophysical and geologic data available (seismic, well logs, cores) and the data needed to model rock heterogeneities at the reservoir scale, constraints from external analog systems are needed. Existing stratigraphic concepts and deposition models are mostly empirical and seldom provide quantitative constraints on fine-scale reservoir heterogeneity. Current reservoir modeling tools are challenged to accurately replicate complex, nonstationary, rock heterogeneity patterns that control connectivity, such as shale layers that serve as flow baffles and barriers.
Request a visit from Tao Sun!
The carbonate sequences that were deposited in the now exhumed Tethyan Ocean influence many aspects of our lives today, either by supplying the energy that warms our homes and the fuel that powers our cars or providing the stunning landscapes for both winter and summer vacations. They also represent some of the most intensely studied rock formations in the world and have provided geoscientists with a fascinating insight into the turbulent nature of 250 Million years of Earth’s history. By combining studies from the full range of geoscience disciplines this presentation will trace the development of these carbonate sequences from their initial formation on the margins of large ancient continental masses to their present day locations in and around the Greater Mediterranean and Near East region. The first order control on growth patterns and carbonate platform development by the regional plate-tectonic setting, underlying basin architecture and fluctuations in sea level will be illustrated. The organisms that contribute to sequence development will be revealed to be treasure troves of forensic information. Finally, these rock sequences will be shown to contain all the ingredients necessary to form and retain hydrocarbons and the manner in which major post-depositional tectonic events led to the formation of some of the largest hydrocarbon accumulations in the world will be demonstrated.
Request a visit from Keith Gerdes!
Engineering of wind farms, development of carbon sequestration projects in shelfal waters, the proliferation of communication cables that connect the world, all of these things suggest that it is time to re-examine what we know about shelf processes both updip-to-downdip and along shoreline, and the influence of shelf processes on erosion and transport of sediments.
Request a visit from Lesli Wood!